White Outdoor 933R, 933E manual Assembly, Contents of Hardware Bag

Section 2: Assembly

Contents of Hardware Bag

(Parts are shown at actual size unless noted otherwise)

	Cotter Pin, 3/32" x 5/8"
	Qty: 6
Flat Washer, 5/16"	Hex Flange Lock Screw,	Hex Flange Lock Screw,
		1/4"-20 x 1/2" Qty: 2
Qty: 4	5/16"-18 x 3/4" Qty: 2

Hex Flange Lock Nut,		Plastic Cable Tie
	1/4-20" Qty: 2	(shown reduced size)
			Shift Link - Gear Select Lever
		Qty: 1 (Recoil Start Model)
			(shown reduced size) Qty: 1
		Qty: 3 (Electric Start Model)

Oil Drain Tube (shown reduced size) Qty. 1	Shift Rod Mounting Plate
( for changing oil - see Maintenance Section )	(shown reduced size) Qty: 1

(Parts shown below are for electric start model)

Battery Charger Qty: 1
	Ignition Keys Qty: 2
(shown reduced size)	(shown reduced size)

A
	E
D	D

Figure 2-2: Attach handlebars and struts to engine deck.

STEP 3: Electric Start Model

A. Secure Wire Harness

1.At the unattached end of the electrical wire harness, there are four wires at- tached to a large plastic connector and two wires attached to a small plastic connector. Plug the large connector into the bottom of the ignition keyswitch that is located on the underside of the han- dlebar console (not pictured).

2.Use two cable ties to secure the wire harness to the right handlebar and away from any moving parts. Place the ties an equal distance apart.

B. Attach Wire Leads to Battery

1.The battery is located at the rear, right-side of the engine deck.

2.At the lower end of the electrical wiring harness, locate a red wire lead and a black wire lead.

•Plug terminal on red (positive) wire into red terminal (U, Figure 2-3) on battery.

•Plug terminal on black (negative) wire into black terminal (V).

3.If applicable, attach wire harness to engine deck using J-clips (W, Figure 2-4) as shown. Bend J-clips over to secure.

5