White Rodgers 1F94W-71 manual Until

To correct this, remove the thermostat from the wall and remove the battery for at least two minutes. After reinstalling the battery, the thermostat will revert to the factory pre- set program until you reprogram the ther- mostat. If you don’t want to reprogram the

thermostat immediately, press	SYSTEM	until
	HEAT/EMER/OFF/
	COOL/AUTO

OFF is displayed and replace the thermo-

stat on the wall. Then press PRGMRUN to begin the factory preset program.

To prevent further static discharge prob- lems, touch another object to release static build-up before touching the thermostat. See OPERATING YOUR THERMOSTAT.

7.Why won’t the setpoint temperature go to the temperature I want?

In the AUTO mode, the highest heating

setpoint temperature you select must be at least 1°F lower than the lowest cooling

setpoint temperature you select (for ex- ample, if 70°F is your lowest selected cool-

ing temperature, you cannot select a heat- ing temperature any higher than 68°F). If such a conflict exists, set the lowest cooling temperature higher in order to set the heat- ing temperature higher. To set a lower cool- ing temperature, you must select a lower heating temperature. See PROGRAMMING YOUR THERMOSTAT.

35