To correct this, remove the thermostat from the wall and disconnect the battery. Wait about two minutes, then reconnect the bat- tery. The thermostat will revert to the factory preset program until you reprogram the thermostat. If you don’t want to reprogram
the thermostat immediately, press SYSTEM
HEAT - OFF - COOL - AUTO
until OFF is displayed and replace the ther-
mostat on the wall. Then press SYSTEM until
HEAT - OFF - COOL - AUTO
HEAT, COOL, etc. is displayed, and press
RUN to begin the factory preset program.
PRGM
Or you may reprogram the thermostat, then replace it on the wall.
To prevent further static discharge prob- lems, touch another object to release static
7.Why won’t the setpoint temperature go to the temperature I want?
The highest heating setpoint temperature you select must be at least 1°F lower than
the lowest cooling setpoint temperature you select (for example, if 70°F is your lowest selected cooling temperature, you cannot
select a heating temperature any higher than 69°F). If such a conflict exists, you must set the lowest cooling temperature higher in order to set the heating tempera- ture higher. To set a lower cooling tempera- ture, you must select a lower heating tem- perature. See PROGRAMMING YOUR THERMOSTAT.
35
