Wolf C36(S,C), C60(S,C)(S,C), C48(S,C), C72(S,C)(S,C) operation manual Leg/Caster Assembly

LEG/CASTER ASSEMBLY

The range is shipped fully assembled, except for the legs. The range is provided with 6"(152 mm) adjustable stainless steel legs (hardware included), packaged in a box located inside of the oven. A set of 6"(152 mm) casters are available as an optional field installable accessory.

RANGE SERIES	LEGS TO INSTALL	CASTERS TO INSTALL
C24	4	4
C36	4	4
C48	6	6
C60	6	6
C72	6	6

Installation of Legs/Casters:

1.Carefully tip range on its side.

2.Align holes in leg/caster mounting plate with pre-drilled holes in bottom of range located in each of the four corners. Two additional legs/casters must be installed on the C48, C60, and C72. The additional legs/casters should be installed utilizing the pre-drilled holes shown in Figure 1.

Figure 1 - Cross Chassis Leg/Caster Mounting

3.Attach mounting plate to bottom of range using four ¼ - 20 x ⅝“ self tapping screws (provided). If casters are being installed, the locking casters should be mounted on the front.

4.After all legs/casters have been installed, carefully return the range to its upright position.

(For additional leg information, see Leveling section of this manual).

Ranges mounted on casters must use a flexible connector (not supplied by Wolf) that complies with the Standard for Connectors for Movable Gas Appliances, ANSI Z21.69•CSA 6.16 and a quick-disconnect device that complies with the Standard for Quick-Disconnect Devices for Use With Gas Fuel, ANSI Z21.41•CSA 6.9. In addition, adequate means must be provided to limit movement of the appliance without depending on the connector and the quick-disconnect device or its associated piping to limit appliance movement. Attach the restraining device at the rear of the range.

- 5 -