![](/images/new-backgrounds/1063253/6325327x1.webp)
WOLF GA S CO O K TO P S
COOKTOP I N S TA L L AT I O N
Remove the cooktop, burner grates and burner caps from the shipping package.
Lower the cooktop into the countertop
IMPORTANT NOTE: When repositioning the cooktop in the countertop
Remove the foam strip from the hardware package. Apply the foam strip around the bottom of the burner box flush with the edge as shown in the illustration below.
Reinsert the cooktop into the countertop opening. Check that the cooktop is parallel to the front edge of the countertop. Lift the entire cooktop to make adjustments and align the rear edge with the pencil line.
Attach the brackets to the burner box. Insert the 89 mm clamping screws into the brackets. Use a screwdriver to tighten the clamping screws against the underside of the counter- top. Refer to the illustration below. Do not overtighten screws.
GAS LEAK TESTING
Use a brush and liquid detergent to test all gas connections for leaks. Bubbles around connec- tions will indicate a leak. If a leak appears, shut off gas valve controls and adjust connections.
Then check connections again. Clean all the detergent solution from the cooktop.
Never test for a gas leak with a match or other flame.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Cooktop | Foam | |||
Burner Box | Strip | |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Foam strip application
|
| Countertop |
Burner Box |
|
|
Bracket | Bracket | 89 mm |
| Screws | Clamping |
|
| Screw |
Bracket installation
14