Wolf ICBSRT304 installation instructions S S U P P LY Requirements, Explosion Hazard

IMPORTANT NOTE

This installation must conform with local codes and ordinances.

WOLF S E A L E D B U R N E R R A N G E TO P

I N S TA L L THE RANGETOP

Prepare the finished rough opening for the rangetop according to the Installation Specifi- cations illustration for your model on pages 9–11. The platform must be 19 mm thick and include a cut-out at the right rear for gas supply and electrical connections.

IMPORTANT NOTE: The platform must be level to ensure that the cooking surface is level.

Remove and discard all packing materials, including cardboard and tape on the outside of the rangetop. Remove the burner grates and styrofoam off the top cooking surface. Be sure to remove the burner caps packaged in styrofoam below the burner grates.

If your installation requires a riser, it must be attached to the rangetop before installation. Refer to the installation instructions packaged with the riser.

Position the rangetop on the platform. Gas supply and electrical connections should be made before the rangetop is placed in its final position.

G A S S U P P LY REQUIREMENTS

EXPLOSION HAZARD —

Securely tighten all external gas connections.

Failure to do so can result in explosion, fire or death.

IMPORTANT NOTE: The sealed rangetop must be connected to a regulated gas supply.

IMPORTANT NOTE: This installation must conform with local codes and ordinances.

The rating plate, located on the underside of the burner box, has information on the type of gas that should be used. If this information does not agree with the type of gas available, check with the local gas supplier.

An ISO 7-1 gas inlet thread is provided on all units. Please contact your local Wolf dealer if an ISO 228-1 or other gas inlet thread is required. Pipe joint compounds, suitable for use with LP gas should be used. LP gas suppli- ers usually determine the size and materials used on the system.

If local codes permit, a flexible metal appliance connector is recommended for connecting this sealed rangetop to the gas supply line. Do not kink or damage the flexible connector when moving the sealed rangetop. You will need to determine the fittings required, depending on the size of your gas supply line, flexible metal connector and shut-off valve.

If rigid pipe is used as a gas supply line, a combination of pipe fittings must be used to obtain an in-line connection to the sealed rangetop. All strains must be removed from the supply and gas lines so the sealed rangetop will be level and in line.

12