Woods Equipment 1023000 Mount Backhoe to Tractor, Hydraulic System Check List, Installation

Mount Backhoe to Tractor

„This mounting kit is designed to provide secure mounting and adequate operator clear- ance for most operators when properly installed. Check clearance dimensions shown below to be sure you have installed seat bracket correctly. In some cases it may be necessary to adjust the seat to the lowest position and/or as far forward as possible in order to achieve the ideal 40-inch clearance. For 36.5-inch radius operation, taller operators may need to wear a hardhat for greater comfort and safety.

„The only time the backhoe may be operated

from a position other than the operator seat is during backhoe attachment￿￿￿￿￿￿￿and removal. Opera- tor must:

•Read Mounting Kit Manual instructions on attaching and removing backhoe and use extreme care.

•Always stand between rear tire and backhoe stabilizer arms or along side of tractor to avoid being trapped should the boom swing control be accidentally activated.

„Remove seat and upper support assembly before installing or removing backhoe from power unit. Failure to comply may result in equipment failure and/or personal injury.

Hydraulic System Check List

Complete check list prior to backhoe operation.

____ Check that backhoe hydraulic pump is

secured to the tractor PTO, if equipped.

____ Check all hydraulic fittings and lines to be

sure they are tight and free of kinks or twists.

____ Check the backhoe hydraulic reservoir (if

equipped) to make sure backhoe PTO driven hydraulic system is full (approximately 6.5 to 7 US gallons). Service if necessary.

NOTE: See the BH90-X Backhoe Operator’s Manual for hydraulic oil recommendations. Do not mix hydraulic fluid types.

Mount Backhoe

1.Remove the backhoe seat assembly.

2.Back tractor up to backhoe and center mount between the tractor rear tires. Position tractor so that the hydraulic system can be connected. Shut off tractor, set brake, remove key.

3.Attach backhoe hydraulic system.

A. Connect hydraulic hoses. See Figure 16.

OR

B. Connect hydraulic pump.

3.With the tractor PTO and transmission in neutral, start the engine and run at low idle. Hydraulic power is provided when the tractor is started.

NOTE: Very little engine power is required to operate the hydraulic system in this mode. Should the engine pull down excessively, check the plumbing hook-up for reversed lines or a con- trol lever stuck in an operating position.

NOTE: You will use the backhoe hydraulics to maneuver the backhoe brackets into position. Use care in this procedure to avoid being trapped between tractor and backhoe or between back- hoe parts.

(Continued on next page)

MAN0579 (1/19/2007) Installation 13