from being run over ￿￿￿￿￿￿￿or crushed. Keep foldable

ROPS system in “locked up” position at all times.

„Never leave equipment unattended with engine running or with bucket in raised position. Always engage swing and boom transport locks, relieve system pressure by operating controls, and remove ignition key before leaving equipment.

Transport and Swing Lock Installation

IMPORTANT

Before operating backhoe, disengage transport lock bar and store swing lock pin. Push transport lock bar down fully to prevent damage.

Engage transport lock by fully retracting boom and dip- per. Position transport latch plate (1), located on right side of swing frame, over transport lock pin (2). Secure with safety pin (4). See Figure 10.

Center boom from side to side and install swing lock pin (6) through plates (8) and swing frame (7). Place swing lock pin (6) in storage hole (9) when not in use.

Always raise stabilizers before transporting backhoe.

REMOVING AND STORING BACKHOE

„The only time the backhoe may be operated from a position other than the operator seat is dur-

ing backhoe attachment and removal. Operator

Read Mounting ￿￿￿￿￿￿￿Kit Manual instructions on attaching and removing backhoe and use extreme care.

Always stand between rear tire and backhoe stabilizer arms or along side of tractor to avoid being trapped should the boom swing control be accidentally activated.

„Keep all persons away from operator control

area while performing adjustments, service, or maintenance.must:

Figure 10. Transport and Swing Lock Installed

3-Point Hitch Saf-T-Lok®

Center the boom, install swing lock pin, then extend boom and dipperstick. Rest bucket on the ground. Lower stabilizers to take backhoe weight off of tractor.

Remove pin that attaches top link to tractor. Remove lower 3-point arms from backhoe. Place blocks under mainframe and raise stabilizers to lower backhoe main- frame onto blocks. Block backhoe as necessary to make it stable.

Disconnect hydraulic pump from tractor and store off ground. Slowly drive tractor away from backhoe.

CLEANING

After Each Use

Remove large debris such as clumps of dirt, grass, crop residue, etc. from machine.

16 Operation

51861 (Rev. 6/16/2006)

 

 

Page 16
Image 16
Woods Equipment 1050 Transport and Swing Lock Installation, Removing and Storing Backhoe, Point Hitch Saf-T-Lok, Cleaning