PRE-OPERATION CHECK LIST (OWNER'S RESPONSIBILITY)
___ | Review and follow all safety rules and safety |
| decal instructions on page 7 through page 12. |
___ | Check that equipment is properly and securely |
| attached to tractor. |
___ | Make sure driveline |
| pin or collar slides freely and is seated firmly in |
| tractor PTO spline groove. |
___ | Set tractor PTO at 540 rpm. |
___ | Lubricate all grease fitting locations. Make sure |
| PTO shaft slip joint is lubricated. |
___ | Check to be sure gear lube runs out the small |
| check plug on side of gearbox. |
___ | Check that all hardware is properly installed |
| and secured. |
___ Check that blades are sharp and secure and cutting edge is positioned to lead in a counter- clockwise rotation.
___ Check that shields and guards are properly installed and in good condition. Replace if damaged.
___ Check cutting height,
___ Place tractor PTO and transmission in neutral before starting engine.
___ Inspect area to be cut and remove stones, branches, or other hard objects that might be thrown and cause injury or damage.
MAN0654 (Rev. 10/19/2007) | Operation 19 |
|
|