Install Tongue
1.Align tongue (1) with top holes on the inside of mast plates.
2.Assemble 3/4 x
3.Attach attitude rod (27) to tongue as shown in Figure 35. Secure with clevis pin (9) and cotter pin (20).
4.Attach
5.Raise front of cutter and install parking jack (28) to support tongue.
6.Attach safety tow chain (26) to tongue using 3/4 x
1.Tongue
2.3/4 Flat washer
3.3/4 Washer, thick
4.3/4 NC x
5.
6.Drive shaft shield
7.5/8 x
8.3/16 x
9.1.00 x 2.26 Clevis pin
11.5/8 x
12.1/2 NC x
13.1/2 Scdl pipe 40 x
14.1/2 Heavy lock washer
15.1/2 Heavy hex nut
16.3/8 NC x 1 HHCS
17.3/8 Standard lock washer
18.3/4 x
19.3/4 Lock nut
20.1/4 x
21.
22..062 x 72 mm ID Snap ring
23.
24.1/4 - 28 x 90° Grease fitting
25.Hydraulic hose holder
26.Safety chain assembly
27.Attitude rod
Figure 35. Tongue and
40 Assembly | MAN0654 (Rev. 10/19/2007) |
|
|