ASSEMBLE BB840XP (PULL-TYPE)
Install Tailwheel Yoke
Refer to Figure 34.
1.Position
2.Attach wheel yoke brackets to rear deck lugs using two clevis pins, secure with cotter pins.
3.Attach wheel and hub using 1/2" x 3" bolts and 1/2" nuts.
Install Attitude Rod
1.Place attitude rod into pivot block in wheel yoke. The rod is a very tight fit; use care to prevent thread damage.
2.Loosely install spacer, washer, and nuts on end of attitude rod.
Install Height Adjustment Device
Ratchet
1.Place one end of ratchet (13) over lug on deck and secure with pin (4) and cotter pins (6).
2.Attach opposite end of ratchet (13) over lug on tailwheel and secure with pin (12) and two cotter pins (6).
Cylinder
1.Place base end of hydraulic cylinder (14) around lug on deck and secure with pin (4) and cotter pins
(6).
2.Extend cylinder rod, place transport lock bracket
(18)over cylinder rod end and around lug on tailwheel.
3.Align holes of cylinder rod, transport lock bracket and lug on tailwheel. Secure assembly using pin
(12)and cotter pins (6).
Install Hydraulic Hose
On
NOTICE
■If using a cylinder other than the one supplied by Woods, make sure a breather fitting is installed in the cylinder rod end port. Use a restricter fitting in the base end port to dampen the cutter lowering action.
1.Install reducer bushing (15) and restricter elbow
(16)in port at base end of cylinder (14). Position elbow to point toward front of cutter.
NOTE: Make sure there is a breather fitting installed in the rod end port.
2.Connect hose (17) to elbow (16).
3.Install optional stroke control kit (19) to cylinder rod. Stroke control kit is used to set cut height.
Install SMV Emblem
1.Align holes of manual tube (20) and SMV mounting bracket (21) and attach both items to deck using cap screws (22) washers (23), lock washers (24) and hex nuts (25).
2.Attach SMV socket (26) to SMV mounting bracket using two carriage bolts (27) and lock nuts (28).
3.Attach SMV emblem (29) to SMV bracket (30) using two round head cap screws (31) and hex nuts (32).
4.Insert SMV bracket (30) and emblem (29) into socket (26).
38 Assembly | MAN0654 (Rev. 10/19/2007) |
|
|