2.Check chain bracket
3.3/8 Chain,
4.3/4 NC x 6 Cap screw GR5
5.3/4 NC Lock nut
6.5/8 NC x
7.5/8 Flat washer
8.5/8 NC Hex nut
9.Mast Plate
10.Tractor top link bracket
Figure 38. Optional Check Chain Assembly
INSTALL CHECK CHAIN (OPTIONAL)
Check chains are used to carry the front of cutter at a set height. See Figure 38.
1.Thread check chains (3) through check chain bracket (2).
2.Attach lower end of check chain (3) to mast plate
(9) with bolt (6), washer (7), and nut (8).
3.Attach keyhole brackets (2) to each side of tractor top link bracket (10) with bolt (4) and nut (5).
1.Remove the rear baffle and hardware.
2.Replace the two 3/8" carriage bolts that were removed from each side of the rear frame. Torque to 35
3.Turn the baffle
4.Secure baffle to the brackets attached to each of the side frames with 3/8
5.Tighten all hardware 35
RELOCATE BAFFLE
NOTE: Baffle may need to be relocated to the front of the cutter to prevent excessive
1. 3/8 NC x 1
2. 3/8 NC x 1 Carriage bolt
3. 3/8 NC Flange lock nut
Figure 39. Baffle Installation
42 Assembly | MAN0654 (Rev. 10/19/2007) |
|
|