1. Rear drive half
2. Front drive half
3.
4. 1/2 x
5. 3/16 x
6. Drive shaft shield
7. 3/8 NC x 1 GR5 Cap screw
8. 3/8 Lock washer
9. 1/2 NC x
11. 1/2 Lock washer
12. 1/2 Hex nut
13. Clutch shield
14. 5/16 Flat washer
15. 8 x 1.25P x 20 mm Cap screw
16. 5/16 Lock washer
17. 12 x 1.5P x 65 mm Cap screw
18. 12 mm Hex lock nut
19.
Figure 36.
Install Three-Joint Drive
Refer to Figure 36.
1.Position shield (13) against the gearbox and secure with cap screw (15), lock washer (16), and flat washer (14). Torque to 12
2.Attach rear half (1) of drive to PTO shaft and secure with two cap screws (17) and lock nuts (18).
3.Grease forward two inches and all sides of rear drive. Slide front drive half (2) onto rear drive.
4.Place carrier bearing holder (3) between
(19)and secure in adjustment hole with clevis pin
(4)and cotter pins (5).
5.Place drive shield (6) over carrier bearing holder and secure with two cap screws (7) and two lock washers (8).
6.Install cap screw (9), sleeve (10), lock washer (11) and hex nut (12) to top hole of
INSTALL DUAL TAILWHEEL
BB720X & BB840X (OPTIONAL)
1.Attach dual tailwheel (1) to main frame (2) using position 5B and desired height adjustment holes as shown in Figure 37.
2.Secure with cap screws (3) and hex nuts (4).
3.Torque hardware to 175
1.Dual tailwheel
2.Deck, BB720X & BB840X
3.5/8 NC x
4.5/8 Flange lock nut
Figure 37. Dual Tailwheel Installation
(Rev. 4/24/2009)
MAN0654 (Rev. 10/19/2007)
Assembly 41