Woods Equipment BB600X, BB840XP manual Assembly, Disassemble Shipping Unit, Connect A-Frame Arms

Disassemble Shipping Unit

Refer to Figure 29.

1.Position cutter flat and place a block underneath the rear of the cutter to raise it off the ground.

2.Remove all parts that are wired or strapped to cutter. Remove parts from manual tube and hardware that is securing tailwheel bracket (6) and brace arms (8) to cutter.

ASSEMBLE MOUNTED CUTTER

Install Tailwheel

4.	Brace arms
5A.	Brace arm mounting hole
5B.	Tailwheel pivot hole
6.	Tailwheel bracket

9.Tailwheel assembly

10.Height adjustment holes

13.5/8 NC x 2 Cap screw

14.5/8 NC Flange lock nut

27.Washer, .18 x 1.62 x 3

28.Spiral pin 3/8 x 2

29.O-Ring

30.Washer

Figure 30. Tailwheel Installation

1.Attach tailwheel bracket (6) to cutter at the tailwheel pivot holes (5B) using cap screw (13) and flange lock nut (14) previously removed.

2.Select desired height adjustment holes (10), and secure tailwheel bracket with cap screws (13) and flange lock nuts (14). Cutting height adjustment will be necessary when cutter is fully assembled. See “Cutting Height Adjustment (Mounted Cutter)” on page 16.

3.Raise rear of cutter and insert tailwheel assembly

(9)into tailwheel bracket (6). Secure with o-ring (29), washer (30), and spiral pin (28).

4.Place diagonal brace bars (4) on the inside of frame rails and attach to diagonal brace mounting holes (5A). Secure using cap screws (13) and flange lock nuts (14).

Connect A-Frame Arms

1.Rotate A-frame arms (9) and break link (8) forward and up.

2.Attach brace arms (11) to the break link (8) using cap screw (36), sleeve (13), and flange lock nut (34).

11	8
	13

34

36

9

DP3

8.Break link

9.A-Frame arms

11. Brace arms

13. Sleeve, .628 x 1.0 x 1.25

34. 5/8 NC Flange lock nut

36. 5/8 NC x 2-3/4 HHCS GR5

Figure 31. Brace Arm Connection

36 Assembly MAN0654 (Rev. 10/19/2007)