Woods Equipment HC54, HC48 manual 14Operation, QUICK HITCH ASSEMBLY HC60 / HC72, Quick Hitch

3. Floating link

5.A-frame

6.Lift bars

7.1/2 x 2-3/4 Spacer

8.1/2 NC x 4 Cap screw

9.1/2 NC Flange lock nut

10.1/2 x 3/4 x 2-13/16 Sleeve

11.1/2 NC x 5 Cap screw

12. .91 x 1.44 x 1.25 Sleeve

13. Cat 1 Mounting pin with hardware

Figure 4. Standard Hitch and Quick Hitch Configurations - HC60, HC72

QUICK HITCH ASSEMBLY (HC60 / HC72)

Refer to Figure 4.

1.Remove brace arms (6), floating link (3), cap screw (11), spacer (7), and flange lock nut (9) from upper hole on A-frame bars (5).

2.Remove hitch pins and place sleeves in hole of diagonal braces. Install hitch pins and tighten at this time.

3.Attach open end of floating link (3) to second hole on top of A-frame bars (5). Secure using cap screw (11), sleeve (10), and flange lock nut (9).

4.Attach closed end of floating link (3) to diagonal braces (6). Secure using cap screw (8), spacer (7), and flange lock nut (9) supplied in hardware bag. Tighten all hardware and hitch pins.

NOTE: Top hook on quick hitch will pick up on sleeve (10). Bottom quick hitch hooks will attach to cutter hitch pins. Category I hitch pins will require bushings (PN 38214) to be installed over hitch pins before connection to quick hitch.

5.Install sleeve (12) over hitch pins and secure with klick pin before connecting to quick hitch.

6.Raise cutter to transport position and adjust tractor top link until cutter is level in the raised position.

ATTACH CUTTER TO TRACTOR

Standard Hitch

1.Attach tractor 3-point arms to hitch pins and secure with klik pins.

2.Attach tractor top link to the floating link and adjust as necessary. See Top Link Adjustment, page 13.

3.Adjust the tractor lower 3-point arm anti-sway devices to prevent cutter from swinging side to side.

Quick Hitch

1.Attach tractor 3-point arms to hitch pins and secure with klik pins.

2.Attach tractor with the quick hitch to the cutter and secure according to the quick hitch manufacturer's instructions. Adjust tractor top link as necessary. See Top Link Adjustment, page 13.

3.Adjust the tractor lower 3-point arm anti-sway devices to prevent cutter from swinging side to side.

14Operation

(Rev. 5/9/2008) MAN0670 (11/16/2007)