DRIVELINE SHEAR BOLT REPLACEMENT
NOTICE
Always use approved 1/2" NC x 3" grade 2 shear bolt as a replacement part. Using a hardened bolt or shear pin may result in damage to driveline or gearbox.
1.Remove driveline shield bell (1).
2.Remove damaged shear bolt (4).
3.Rotate driveline to align holes in yoke and shaft. Install shear bolt and secure with lock nut. Replace driveline shield bell.
1.Drive shield
2.Gearbox input shaft
3.1/2 NC Lock nut
4.1/2 NC x 3 Cap screw GR2
5.Gearbox
6.Retaining ring
Figure 15. Shear Bolt Driveline Assembly
SHIELDING REPAIR
Full chain, rubber, or steel band shielding, designed to reduce the possibility of thrown objects, must be installed when operating in popu- lated areas or other areas where thrown objects could injure people or damage property. If this machine is not equipped with full chain, rubber, or steel band shielding, operation must be stopped when anyone comes within 300 feet.
Rear Band
Inspect rear band each day of operation and replace if bent, cracked or broken.
Rubber Shielding
Inspect rubber shielding each day of operation and replace if cracked or broken.
Optional Chain Shielding
Inspect chain shielding each day of operation and replace any broken or missing chains as required.
CLEANING
After Each Use
●Remove large debris such as clumps of dirt, grass, crop residue, etc. from machine.
●Inspect machine and replace worn or damaged parts.
●Replace any safety decals that are missing or not readable.
Periodically or Before Extended Storage
●Clean large debris such as clumps of dirt, grass, crop residue, etc. from machine.
●Remove the remainder using a
1.Be careful when spraying near scratched or torn safety decals or near edges of decals as water spray can peel decal off surface.
2.Be careful when spraying near chipped or scratched paint as water spray can lift paint.
3.If a pressure washer is used, follow the advice of the pressure washer manufacturer.
●Inspect machine and replace worn or damaged parts.
●Sand down scratches and the edges of areas of missing paint and coat with Woods spray paint of matching color (purchase from your Woods dealer).
●Replace any safety decals that are missing or not readable (supplied free by your Woods dealer). See Safety Decals section for location drawing.
MAN0670 (11/16/2007) | Owner Service 21 |
|
|
