Woods Equipment HC54, HC48, HC72, HC60 manual Dealer Service, Crossbar Installation

1.Clevis

2.5/8 NC x 4 Cap screw

3.5/8 NC Hex nut

4.Pad assembly

5.Tube assembly

6.Screw assembly

7.Puller link

Figure 19. Crossbar Removal

CROSSBAR INSTALLATION

2.Install crossbar (2) on splined shaft. Install washer, castle nut, and cotter pin. Torque nut to200 lbs-ft.

1. Using emery cloth (220 or finer), remove surface	3. Install the blades. See Blade Installation, page 19
rust, Loctite® and foreign material from hub,
splined gearbox, vertical shaft, and crossbar as
shown in Figure 20.

Figure 20. Figure 21

28 Dealer Service

(Rev. 6/27/2008) MAN0670 (11/16/2007)