Woods Equipment HC60, HC54 Operation, Driveline Installation Tractor Pto, To Install, To Remove

Models: HC60 HC72 HC48 HC54

1 54
Download 54 pages 16.95 Kb
Page 15
Image 15
DRIVELINE INSTALLATION (TRACTOR PTO)

DRIVELINE INSTALLATION (TRACTOR PTO)

Make sure spring-activated locking pin or collar slides freely and is seated firmly in tractor PTO spline groove.

To Install:

Pull locking collar back and at the same time push the driveline onto tractor PTO shaft until locking device engages.

To Remove:

Hold driveline into position, pull locking collar back, and slide driveline off tractor PTO shaft.

Figure 5. Lock Collar

DRIVELINE ADJUSTMENT

Attach the cutter to the tractor 3-point hitch (or quick hitch if available). Do not attach driveline. Raise and lower cutter to determine maximum and minimum dis- tance between the tractor PTO shaft and the gearbox input shaft. If the distance is too large, the driveline will be too short for proper engagement. If distance is too

small, the driveline may bottom out in operation and damage the cutter or tractor.

The driveline length must be sufficient to provide at least 1/3 driveline length of engagement during normal operation. There must be at least 4 inches of engage- ment at the cutter’s lowest possible point of operation. Driveline must not bottom out when raised to the maxi- mum height possible.

If driveline is too short, please call your Woods dealer for a longer driveline.

If driveline is too long, please follow the instructions for shortening the driveline.

SHORTEN DRIVELINE

1.Move cutter up and down to get the shortest possible distance between tractor PTO shaft and gearbox input shaft.

2.Separate driveline into two halves and connect them to the tractor PTO and gearbox.

3.Place driveline halves parallel to one another to determine how much to shorten the driveline.

DP2

Figure 6. Drive Halves Placed Parallel

4.Measure from end of the upper shield to the base of the bell on the lower shield (A). Add 1-9/16" to dimension (A). See Figure 7.

A

1-9/16"

DP3

Figure 7. Determine Shield Length

5.Cut the shield to the overall dimension.

MAN0670 (11/16/2007)

Operation 15

 

 

Page 15
Image 15
Woods Equipment HC60, HC54, HC48 Operation, Driveline Installation Tractor Pto, To Install, To Remove, Driveline Adjustment