Woods Equipment HC60, HC54, HC48, HC72 manual Assembly, Dealer Set-Upinstructions

ASSEMBLY

DEALER SET-UP INSTRUCTIONS

Assembly of this cutter is the responsibility of the Woods dealer. It should be delivered to the owner com- pletely assembled, lubricated, and adjusted for normal cutting conditions.

The cutter is shipped partially assembled. Assembly will be easier if aligned and loosely assembled before tightening hardware. Recommended torque values for hardware are located in the Bolt Torque Chart, page 47.

Complete Dealer Check Lists, page 34 when you have completed the assembly.

(92 m).

•This shielding is designed to reduce the risk of thrown objects. The mower deck and protec- tive devices cannot prevent all objects from escaping the blade enclosure in every mowing condition. It is possible for objects to ricochet and escape, traveling as much as 300 feet (92 m).

Make sure spring-activated locking pin or collar slides freely and is seated firmly in tractor PTO spline groove.

CAUTION

Full chain, rubber, or steel band shielding must be installed when operating in populated areas or other areas where thrown objects could injure peo- ple or damage property.

•If this machine is not equipped with full chain, rubber, or steel band shielding, operation must be stopped when anyone comes within 300 feet

Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hair, hands, hearing, and head; and respirator or filter mask where appropriate.

1.	Diagonal brace		10	9
2.	Tailwheel bracket	C
3.	Tailwheel		4
4.	Height adjustment
5.	5/8 NC x 2 HHCS				A
6.	5/8 NC Flange	B
	lock nut
					5
9.	1/2 NC x 1-1/2
	HHCS			2	6
10.	1/2 NC Flange
	lock nut				1
11.	A-Frame bar	11

A. Diagonal brace &	3
Tailwheel bracket
mounting hole

B.Driveline

C.Clutch shield

DP1

Figure 28. Shipping Configuration

MAN0670 (Rev. 6/27/2008) Assembly 31