Woods Equipment RBC60 LRC60 Assembly Instructions, Dealer Set-Up Instructions, Assemble Blade

ASSEMBLY INSTRUCTIONS

DEALER SET-UP INSTRUCTIONS

Assembly of this Rear Blade/Landscape Rake is the responsibility of the WOODS dealer. It should be deliv- ered to the owner completely assembled, lubricated and adjusted for normal cutting conditions.

The Rear Blade/Landscape Rake is shipped partially assembled. Assembly will be easier if components are aligned and loosely assembled before tightening hard- ware. Recommended torque values for hardware are located on page 24.

„Before dismounting power unit or performing any service or maintenance, follow these steps: disengage power to equipment, lower the 3-point hitch and all raised components to the ground, operate valve levers to release any hydraulic pres- sure, set parking brake, stop engine, remove key, and unfasten seat belt.

„NEVER GO UNDERNEATH EQUIPMENT. Never place any part of the body underneath equipment or between moveable parts even when the engine has been turned off. Hydraulic system leak-down, hydraulic system failures, mechanical failures, or movement of control levers can cause equipment to drop or rotate unexpectedly and cause severe injury or death.

•Service work does not require going under- neath.

•Read Operator's Manual for service instruc- tions or have service performed by a qualified dealer.

„Keep all persons away from operator control area while performing adjustments, service, or maintenance.

CAUTION

„Always wear relatively tight and belted clothing to avoid entanglement in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hair, hands, hearing, and head; and respirator or filter mask where appropriate.

Assemble Blade

Attach Pivot Assembly to Moldboard

1.Remove two plow bolts (28) from center moldboard

(5) and cutting edge.

2.Remove two carriage bolts (26) from top of moldboard.

3.Align holes on pivot assembly (6) with holes on moldboard.

4.Secure pivot assembly to moldboard using hardware previously remove. Use plow bolts (28), hardened flat washer (25), and hex nut (24) in the bottom two holes and carriage bolts (26), hardened flat washer (25), and hex nut (24) in the top two holes.

	24
	25
24
25
6	CD6156-2
	26
5
	28
5.	Moldboard
6.	Pivot assembly
24.	5/8 NC Hex nut
25.	5/8 Hardened flat washer
26.	5/8 NC x 1-1/2 Carriage bolt GR5
28.	5/8 NC x 2 Plow bolt

Figure 12. Pivot Assembly to Moldboard

Attach Rear Blade Frame to Pivot Assembly

1.Remove pivot cap (3) and hardware from pivot assembly (6).

2.Support moldboard in an upright position.

3.Place rear blade frame assembly (9) over pivot tube on pivot assembly (6).

MAN0169 (Rev. 5/6/2005) Assembly 15