9 | DP4 |
|
12
13
9.Tail wheel arm
12.1/2 Flange lock nut
13.1/2 NC x
Figure 15. Caster Wheel Installed
Install Optional Skid Shoe Kit
(Rear Blade)
1.Remove plow bolts from each end of cutting edge.
2.Attach skid shoe bracket (1) to rear of moldboard with plow bolt (2), washer (3), and hex nut (4) supplied in kit.
3.Adjust skid shoe to desired height.
4.Repeat steps for opposite side of moldboard.
| 1 |
| 2 |
3 | |
1. | Skid shoe bracket |
2. | 5/8 NC x 2 Plow bolt |
3. | 5/8 Hardened flat washer |
4. | 5/8 NC Hex nut |
Figure 16. Skid Shoe Installation (Typical)
Figure 17. Skid Shoe Installed (Right Side)
Quick Hitch Bushing Kit (Optional)
|
| 5 | 6 |
| 3 | 4 | |
|
| ||
2 |
|
|
|
|
| CD6221 |
|
| 1 |
|
|
1. | .938 x 1.438 x 1.19 Sleeve |
| |
2. | 7/16 x 11/32 Klik pin |
| |
3. | 3/4 NC Hex nut |
| |
4. | 3/4 Lock washer |
| |
5. | .812 x 1.25 x 1.75 Sleeve |
| |
6. | 3/4 NC x 3 Cap screw GR5 |
|
Figure 18. Quick Hitch Bushing Kit
1.Place sleeve (1) over lower
2.Place sleeve (5) between
(4) and nut (3).
MAN0169 (Rev. 5/6/2005) | Assembly 17 |
|
|