4.Secure rear blade frame assembly to pivot assembly using pivot cap (3), two hardened flat washers (25), and hex nuts (24).
5.Place rear blade frame assembly in desired position and secure with hitch pin (8).
6.Place parking stand in the down position to support rear blade. See page 11 for storage.
| 24 |
| 25 |
8 | 3 |
| |
| 9 |
6 | CD6155A |
| |
3. | Pivot cap |
6. | Pivot assembly |
8.Hitch pin
9.Rear blade frame assembly
24.5/8 NC Hex nut
25.5/8 Hardened flat washer
Figure 13. Rear Blade Frame to Pivot Assembly
Assembly Landscape Rake
1.Place jack stands or suitable blocking device under tine beam so pivot tube is pointing upward.
2.Remove pivot cap (3) and hardware from tine beam (1).
3.Place rear blade frame assembly (9) over pivot tube on tine beam (1).
4.Secure rear blade frame assembly to tine beam using pivot cap (3), two hardened flat washers (25), and hex nuts (24).
5.Place rear blade frame assembly in desired position and secure with hitch pin (8).
6.Place parking stand in storage position to support landscape rake. See page 11 for storage.
| 24 |
| 25 |
8 | 3 |
| 9 |
| |
| 1 |
1. | Tine beam |
3. | Pivot cap |
8. | Hitch pin |
9. | Rear blade frame assembly |
24. | 5/8 NC Hex nut |
25. | 5/8 Hardened flat washer |
Figure 14. Landscape Rake Assembly
Install Optional Caster Wheels (Landscape Rake)
1.Remove landscape rake from tractor
2.Roll landscape rake over with tines pointing upward.
3.Place jack stands or suitable blocking device under tine beam to raise tine beam approximately 8 to 10 inches.
4.Place tail wheel arm (9) between lugs on tine beam and align holes.
5.Secure into position using three cap screws (13) and flange lock nuts (12).
16 Assembly | MAN0169 (Rev. 5/6/2005) |
|
|