9.Repeat step 8 for other half of drive.
10.File and clean cut ends of the both drive halves.
Fill Gearbox Oil
NOTICE
■Gearbox is not filled at the factory. Prior to delivery to customer, make sure gearbox is filled only
1.Remove solid plug and discard.
2.Make sure vent plug hole is clear.
3.Fill gearbox until oil runs out the side plug on gearbox. Use a high quality gear oil with a viscosity index of 80W or 90W and an API service rating of
4.Install vent plug supplied in manual tube during assembly.
Install Chain Shielding (Optional)
Full chain, rubber, or steel band shielding must be installed when operating in populated areas or other areas where thrown objects could injure peo- ple or damage property.
•If this machine is not equipped with full chain, rubber, or steel band shielding, operation must be stopped when anyone comes within 300 feet (92 m).
•This shielding is designed to reduce the risk of thrown objects. The mower deck and protec- tive devices cannot prevent all objects from escaping the blade enclosure in every mowing condition. It is possible for objects to ricochet and escape, traveling as much as 300 feet (92 m).
The optional chain shielding assemblies are ready for installation when you receive them.
1.Refer to Front & Rear Chain Shielding, page 47 and attach as shown by inserting the bolts from outside the cutter frame in through the shielding.
2.Use and install hardware as shown in the parts drawing.
MAN0224 (Rev. 9/30/2005) | Assembly 35 |
|
|
