A.Brace arm mounting hole
B.Tailwheel pivot hole
C.PTO Hanger
D.Height adjustment bracket
E.Tailwheel assembly
2.Tailwheel bracket
3.Brace arms
4.Pivot arm
5.Pivot link & hardware
8.Mounting pin & hardware
9.Deflector plate
10.Rubber deflector
RCC42 Assembled
RCC42 Shipping Configuration
Figure 24. RCC42 Shipping Configuration and Assembled Unit
Install Slip Clutch Driveline
|
| NOTICE | |
| ■ | A grade 8 bolt must be used to attach clutch | |
| driveline to gearbox. | ||
| NOTE: A new slip clutch, or one that has been in | ||
| storage over the winter, may seize. | ||
1. | Before operating slip clutch, make sure it will slip. | ||
|
| Refer to Slip Clutch Adjustment on page 18. | |
2. | Position shield (1) against gearbox. Secure shield | ||
|
| to gearbox using four cap screws (2), lock washers | |
Figure 25. Shear Bolt Driveline Assembly | |||
(3), and flat washers (4). | |||
|
| ||
3. | Torque hardware to 12 | ||
4. | Install driveline slip clutch onto gearbox input shaft. | ||
(Rev. 5/2/2008)
MAN0224 (Rev. 9/30/2005)
