Crossbar Installation
1.Using emery cloth (220 or finer), remove surface rust, Loctite®, and foreign material from hub, splined gearbox vertical shaft, and crossbar as shown in Figure 16.
Figure 16. Typical Crossbar Assembly
Refer to Figure 17
2.Install crossbar (2) on splined shaft. Install washer
(3) and nut (4). Torque nut 200
3.Install 6" section of 9 gauge wire (not supplied) through gearbox shaft and slots in nuts. Twist ends of wire together.
4.If you have removed blades, reinstall them using existing hardware. Torque blade pin nut to 450 lbs- ft.
UNIVERSAL JOINT REPAIR
1.Yoke
2.Cup and bearings
3.Snap ring
4.Journal cross
Figure 18.
U-Joint Disassembly
1.Remove external snap rings from yokes in four locations as shown in Figure 19.
Figure 19. Remove Snap Rings
Figure 17. Typical Crossbar Installation
(Rev. 4/4/2011)
MAN0224 (Rev. 7/29/2005)
Dealer Service 29
