4.Hold clutch hub (3) solid and turn shaft to make sure clutch slips.
5.If clutch does not slip freely, disassemble and clean the thrust plate faces (4), flange yoke (1), and clutch hub (3).
6.Reassemble clutch.
7.Tighten spring (5) until it is against the thrust plate
(4)of the clutch, and then back off each of the six
nuts by 2 full revolutions. The gap between spring and thrust plate should be 1/8" as shown in Figure 10.
8.If a clutch continues to slip when the spring is compressed to 1/8" cap, check friction discs (2) for excessive wear. Discs are 1/8" when new. Replace discs after 1/16" wear. Minimum disc thickness is 1/16".
Comer
Model | "A" | "B" |
RCC42 | 1.26" | 7.09" |
|
|
|
Walterscheid
1.Flange yoke
2.Friction disc
3.Hub,
4.Thrust plate
5.Belleville spring plate
6.10 mm x 1.5P x 55 mm Cap screw
7.10 mm x 1.5P Hex nut
Figure 10. Slip Clutch Assembly
(Rev. 3/30/2011)
MAN0224 (Rev. 7/29/2005)
Owner Service 19
