Woods Equipment RCC42 manual Owner Service, Blocking Method, Lubrication Information

OWNER SERVICE

The information in this section is written for operators who possess basic mechanical skills. If you need help, your dealer has trained service technicians available. For your protection, read and follow the safety informa- tion in this manual.

Keep all persons away from operator control area while performing adjustments, service, or maintenance.

Before performing any service or maintenance, disconnect driveline from tractor PTO.

Never go underneath equipment (lowered to the ground or raised) unless it is properly blocked and secured. Never place any part of the body under- neath equipment or between moveable parts even when the engine has been turned off. Hydraulic system leak down, hydraulic system failures, mechanical failures, or movement of control levers can cause equipment to drop or rotate unexpect- edly and cause severe injury or death. Follow Oper- ator's Manual instructions for working underneath and blocking requirements or have work done by a qualified dealer.

CAUTION

If you do not understand any part of this manual and need assistance, see your dealer.

BLOCKING METHOD

To minimize the potential hazards or working under- neath the cutter, follow these procedures.

1.Jackstands with a load rating of 1000 lbs. or more are the only approved blocking device for this cutter. Install a minimum of four jackstands, two in front and two in rear (refer to Xs in Figure 7) under the cutter before working underneath unit.

2.Do not position jackstands under wheels, axles, or wheel supports. Components can rotate and cause cutter to fall.

3.Consider the overall stability of the blocked unit. Just placing jackstands underneath will not ensure your safety.

4.The working surface must be level and solid to support the weight on the jackstands. Make sure

jackstands are stable, both top and bottom. Make sure cutter is approximately level.

5.With full cutter weight lowered onto jackstands, test blocking stability before working underneath.

6.If cutter is attached to tractor when blocking, set the brakes, remove key, and block cutter before working underneath.

7.Securely block rear tractor wheels, in front and behind. Tighten tractor lower 3-point arm anti-sway mechanism to prevent side-to-side movement.

LUBRICATION INFORMATION

1.Do not let excess grease collect on or around parts, particularly when operating in sandy areas.

2.See Figure 7 for lubrication points and frequency of lubrication based on normal operating conditions. Severe or unusual conditions may require more frequent lubrication.

3.Use a lithium grease of #2 consistency with a MOLY (molybdenum disulfide) additive for all locations unless otherwise noted. Be sure to clean fittings thoroughly before attaching grease gun. One good pump of most guns is sufficient when the lubrication schedule is followed.

Driveline Lubrication

1.Lubricate the driveline slip joint every eight operating hours. Failure to maintain proper lubrication could result in damage to U-joints, gearbox, and driveline.

2.Lower cutter to ground, disconnect driveline from tractor PTO shaft, and slide halves apart but do not disconnect from each other.

3.Apply a bead of grease completely around male half where it meets female half. Slide drive halves over each other several times to distribute grease.

Gearbox Lubrication

For gearbox, use a high quality gear oil with a viscosity index of 80W or 90W and an API service rating of GL– 4 or –5 in gearboxes.

Fill gearbox until oil runs out the side plug on gearbox. Check gearbox daily for evidence of leakage, and con- tact your dealer if leakage occurs.

16 Owner Service MAN0224 (Rev. 7/29/2005)