Woods Equipment RCC42 manual Owner Service, Notice, SERVICING BLADES Removing Blades

		1.	Front U-joint	8 hrs.
		2.	Slip joint (apply grease..	to male
			shaft)	8 hrs.
		3.	Rear U-joint	8 hrs.
		4.	Gearbox	Daily
	X	5.	Tailwheel pivot tube	8 hrs.
		6.	Tailwheel	8 hrs.
		7.	Plastic Shield Bearing ...	8 hrs.
X		X

X

X = Jackstand Placement

Figure 7. Jackstand Placement and Lubrication Points

SERVICING BLADES

Removing Blades

1.Disconnect driveline from tractor PTO.

2.Raise cutter and block securely (see Figure 7).

3.Open blade access cover and align crossbar (43) with blade access hole in the cutter frame. Remove nut (46) and lock washer (45) using a 1-11/16" socket. Carefully drive blade pin (28) out of crossbar.

NOTICE

■If blade pin (28) is seized in crossbar and extreme force will be needed to remove it, support crossbar from below to prevent gearbox damage.

4. Rotate crossbar (43) and repeat for opposite blade. Figure 8. Blade Assembly

(Rev. 5/2/2008)

MAN0224 (Rev. 7/29/2005)

Owner Service 17