2.With snap rings removed, support drive in vise, hold yoke in hand and tap on yoke to drive cup up out of yoke. See Figure 16.
Figure 16
3.Clamp cup in vise as shown in Figure 17 and tap on yoke to completely remove cup from yoke. Repeat step 2 & step 3 for opposite cup.
Figure 17
4.Place universal cross in vise as shown in Figure 18 and tap on yoke to remove cup. Repeat step 3 for final removal. Drive remaining cup out with a drift and hammer.
Figure 18
U-Joint Assembly
Figure 19
1.Place seals securely on bearing cups. Insert cup into yoke from outside and press in with hand pressure as far as possible. Insert journal cross into bearing cup with grease fitting away from shaft. Be careful not to disturb needle bearings. Insert another bearing cup directly across from first cup and press in as far as possible with hand pressure.
2.Trap cups in vise and apply pressure. Be sure journal cross is started into bearings and continue pressure with vise, squeezing in as far as possible. Tapping the yoke will help.
3.Seat cups by placing a drift or socket (slightly smaller than the cup) on cup and rap with a
26 Dealer Service | 29977 (Rev. 1/23/2009) |
|
|
