D2057A, D2058A, D2260A Mobile Base Instructions
Assembling Base Around Machine
1.Thread a knob several turns into each foot post, as shown in Figure 17.
2.Insert a foot into the bottom of each foot post (see Figure 17). The magnetized knob shaft should pick up the foot when it comes in close proximity.
Foot Post | Knob |
| |
Foot |
|
Figure 17. Installing foot and knob into a
foot post.
3.Slide a side rail inside each of the two corner brackets with the foot posts, then slide the assembly up against the front of the machine or the side that will be pushed (see Figure 18).
4.Move the corner brackets as close to the machine base as possible.
5. Thread (1) 8mm lock nut halfway onto each M8-1.25 x 25 hex bolt with the nylon insert on the nut facing the head of the bolt.
Corner Brackets |
with Knob |
Side Rail |
Figure 18. Rail inserted between corner
brackets with knobs and feet.
6.Secure each end of the rails to the corner brackets with (2) M8-1.25 x 25 hex bolts and 8mm lock nuts, as shown in Figure 19.
Note: Thread the hex bolts into the rails but do not tighten the lock nuts against the rails until instructed.
x 2 | x 2 |
