Woodstock M1036 Compound Slide Table, Vise, To install the compound slide table, do these steps

M1036 Micro Mill

Compound Slide Table

Installation of the compound slide table is not necessary when using the mill as a drill. The compound slide table can be moved in the X and Y axis for use with milling cutters.

To install the compound slide table, do these steps:

1.Thread the handwheel handles into the handwheels.

2.Remove the fence from the base if installed.

3.Slide the T-bolts into the T-slots and place the compound slide table over the T-bolts, as shown in

Figure 8.

4.Measure at the front and back of the compound slide table as shown in Figure 9 to make sure the compound slide table is parallel to the base.

5.Place washers over the T-bolts and secure the com- pound slide table with the hex nuts.

Vise

To install the vise, do these steps:

1.Slide the T-nuts into the compound slide table.

2.Place the vise on the compound slide table and loosely secure it by threading two M6-1 x 18 cap screws with washers through the vise and into the T- bolts, as shown in Figure 10.

3.Align the vise parallel to the compound slide table and tighten the cap screws.

Figure 8. T-bolt installation.

Figure 9. Aligning the compound slide

table.

SET UP

Figure 10. Securing the vise.

-13-