D('+09\eZ_kfgCXk_\ D]^%J`eZ\/&'0
Using the Four-Jaw Chuck
To install the four-jaw chuck, do these steps:
Refer to the :_lZbXe[=XZ\GcXk\Dflek`e^ procedures
on GX^\(0 to mount the
To load a workpiece in the four-jaw chuck, do these steps:
1.Using the chuck key, open each jaw so the workpiece will lay flat against the chuck face and will be roughly centered.
2.Support the workpiece in the center of the chuck as best as you can by eye.
3.Turn each jaw until it just makes contact with the workpiece.
4.While measuring with a dial indicator (see Figure 16), and rotating the chuck by hand, make fine centering adjustments by slightly loosening one jaw and tightening the opposing jaw until the workpiece is precisely aligned.
5.Use a lower RPM when machining heavy eccentric workpieces.
J\Zli\cp ZcXdg pfli nfibg`\Z\ Xe[ i\dfm\ k_\ Z_lZb b\p K_ifne fYa\Zkj ]ifdXY\eZ_kfgcXk_\ZXeZXlj\j\i`flj `ealip fi [\Xk_ kf k_\ fg\iXkfi Xe[ kf YpjkXe[\ijdXep]\\kXnXp%
G@E:??8Q8I;Gifk\Zkpfli_Xe[jXe[ gi\Z`j`fe ^ifle[ Y\[nXpj n`k_ gcp$ nff[ n_\e i\dfm`e^ Y\eZ_kfg cXk_\ Z_lZb K_\ _\Xmp n\`^_k f] X ]Xcc$ `e^ Z_lZb ZXe ZXlj\ j\i`flj `ealip%
=`^li\16% Centering workpiece.
