-27-
D('+09\eZ_kfgCXk_\D]^%J`eZ\/&'0
FG<I8K@FEJ
Using the Follow Rest
The follow rest in Figure 26 is mounted on the saddle and
follows the movement of the tool. The rest requires only
two fingers, as the cutting tool acts as the third.
The follow rest is used on long, slender parts to prevent
flexing of the workpiece during cuttin g.
Note: PfldljkclYi`ZXk\k_\]`e^\ik`gjn`k_f`c[li`e^
fg\iXk`fekfXmf`[k`g^Xcc`e^%8]k\igifcfe^\[lj\#k_\
]`e^\ijn`ccj_fnn\Xi#jfpfln`cc_Xm\kfi\gcXZ\fi]`c\
k_\k`gj]fiXe\nZfekXZkjli]XZ\%
Using the Steady Rest
The steady rest serves as a support for long shafts. The
steady rest can be placed anywhere along the length of
the ways.
To use the steady rest, do these steps:
1. Carefully place the steady rest on the lathe bedways.
2. Loosen the finger lock nuts so the finger position can
be adjusted (see Figure 25).
3. Insert the workpiece, and support it with the chuck
and the tailstock.
4. Position the steady rest along the workpiece where
desired. Tighten the steady rest lock nut (see Figure
25) to secure the steady rest in place.
5. Turn the adjustment knobs so the fingers are snug
against the workpiece and then tighten the finger
lock nuts.
Note: PfldljkclYi`ZXk\k_\]`e^\ik`gjn`k_f`c[li$
`e^fg\iXk`fekfXmf`[k`g^Xcc`e^%8]k\igifcfe^\[
lj\#k_\]`e^\ijn`ccj_fnn\Xi#jfpfln`cc_Xm\kf
i\gcXZ\fi]`c\k_\k`gj]fiXe\nZfekXZkjli]XZ\%
=`^li\26% Follow rest attachment.
=`^li\25% Steady rest adjustments.
Adjustment
Knob
Finger Lock Nut
Steady
Rest
Lock
Nut