D('+09\eZ_kfgCXk_\ D]^%J`eZ\/&'0
FG<I8K@FEJ
Using the Faceplate
The faceplate can be used to turn
Efk\1 K_\`eZcl[\[DK*[\X[Z\ek\in`cc]`k`ekfk_\ jg`e[c\Yfi\n`k_k_\]XZ\gcXk\Xci\X[p`ejkXcc\[%
To install the faceplate, do these steps:
Refer to the :_lZbXe[=XZ\GcXk\Dflek`e^ procedures on GX^\(0 to mount the
To load a workpiece, do these steps: 1. Support the workpiece.
2.Slide the tailstock to the workpiece.
3.Lock the tailstock and then turn the tailstock quill so the dead center makes contact with the center point of your workpiece.
4.Lock the tailstock quill when sufficient pressure is applied to hold the workpiece in place.
Efk\1 ;\g\e[`e^fek_\nfibg`\Z\#jfd\X[[`k`feXc jlggfikdXpY\e\\[\[jlZ_XjXZljkfd]`okli\fi a`^k_XkZXe_fc[k_\nfibg`\Z\]ifd\a\Zk`e^]ifd k_\Z_lZb%
5.Secure the workpiece with a minimum of three independent clamping devices. Failure to follow this step may lead to deadly injury to yourself or bystanders. Take into account rotation and the cutting forces applied to the workpiece when clamping to the faceplate. Make sure your clamping application will not fail!
6.Use a lower RPM when machining heavy eccentric workpieces.
=`^li\17% Faceplate installed.
Lj\ X d`e`dld f] k_i\\ `e[\g\e[\ek ZcXdg`e^[\m`Z\jn_\eklie`e^\ZZ\eki`Z nfibg`\Z\j%=X`cli\kfgifm`[\X[\hlXk\ ZcXdg`e^n`ccZXlj\nfibg`\Z\kf\a\Zk%
J\Zli\cp ZcXdg pfli nfibg`\Z\ Xe[ i\dfm\k_\Z_lZbb\pK_ifnefYa\Zkj ]ifdXY\eZ_kfgcXk_\ZXeZXlj\j\i`flj `ealip fi [\Xk_ kf k_\ fg\iXkfi Xe[ kf YpjkXe[\ijdXep]\\kXnXp%
