D('+09\eZ_kfgCXk_\ D]^%J`eZ\/&'0
Setting Power Feed Rate
FG<I8K@FEJ
The carriage has longitudinal power feed capability of 0.0047, 0.0063, 0.0078, and 0.012 inches per revolution of the chuck. All directions reverse when spindle rotation is reversed.
=\\[ iXk\ `j YXj\[ fe jg`e[c\ IGD% ?`^_ ]\\[ iXk\j ZfdY`e\[n`k__`^_jg`e[c\jg\\[ji\jlck`eXiXg`[cp dfm`e^ ZXii`X^\ fi Zifjj jc`[\% GXp Zcfj\ Xkk\ek`fe kf k_\ ]\\[ iXk\ pfl _Xm\ Z_fj\e Xe[ Y\ i\X[p kf [`j\e^X^\k_\Xgife%=X`cli\kf[fk_`jdXpZXlj\k_\ ZXii`X^\ kf ZiXj_ `ekf k_\ Z_lZb% @] X Zlkk`e^ [\gk_ `jkff^i\Xk#k_\cXk_\dXpY\XYc\kfdXb\k_\Zlk# Ylk[`j\e^X^`e^k_\Xgife]ifdk_\c\X[jZi\nXkk_\ cXjkd`elk\dXpY\[`]]`Zlck%
To set and engage the power feed, do these steps:
1.DISCONNECT THE LATHE FROM POWER!
2.Determine the feed rate that will give you the type of finish you need. For example, in this case the chart shows that 0.0047" is required. The gearbox lever is in position 9 (Figure 34), and install the "60" and
^ch |
| )% | AZkZg | . | * | & | & |
| V | V | '- | '- | '- | )' | |
| )% | ||||||
|
|
|
|
|
| ||
|
|
|
|
|
|
| |
| &'% | &', | W | +% | +% | +% | +% |
|
| ||||||
| W |
| ;ZZY | %#%%), %#%%+( %#%%,- %#%&' | |||
|
|
| |||||
Note: 8ccZ_Xe^\^\XijXi\jkXdg\[n`k_k_\eldY\if] k\\k_k_\p_Xm\Xe[b\\gk_\^\XiYXZbcXj_jc`^_kcp cffj\ at 0.003" to 0.008".
3.Use the leadscrew direction lever to select leadscrew rotation.
4.Set your cutting depth to a few thousandths of an inch, turn the lathe FE, and move the apron feed lever (Figure 36) to engage and disengage the auto feed.
=`^li\34% Gearbox selector in position 0.
V
W
=`^li\35% Change gear locations.
Apron Feed
Lever
=`^li\36% Apron feed lever.
