Woodstock M1099 manual `cc`eN`kk\KX`cjkfZb, Kflj\k\kX`cjkfZb#fk\j\jk\gj1

Df[\cD('00D]^J`eZ\/&'.

KX`cjkfZb

The tailstock (=`^li\(,) can be used to support workpieces with a live or dead center. The lathe can drill or bore holes in the center of a part with a drill bit held by the tailstock. The tailstock can also be offset for cut- ting shallow tapers.

Kflj\k_\kX`cjkfZb#[fk_\j\jk\gj1

(% Slide the tailstock to the desired position.

)% Tighten the tailstock lock nut to lock the tailstock in place on the ways.

*% Loosen the quill lock lever to unlock the quill.

+% Turn the quill feed handwheel clockwise to move the quill towards the spindle or counterclockwise to move away from the spindle.

	Quill Lock Lever
	Offset
	Scale
Tailstock	Offset
Lock Nut	Adjustment

=`^li\(,% Tailstock and quill lock handles

in locked position.

FG<I8K@FEJ

,% Tighten the quill lock lever to lock the quill in place.

;i`cc`e^N`k_k_\KX`cjkfZb

Kfj\klgk_\kX`cjkfZb]fi[i`cc`e^#[fk_\j\jk\gj1

(% With the tailstock locknut tight, unlock the quill lock lever.

)% Turn the quill feed handwheel clockwise to extend the quill about one inch.

*% Insert the MT#3 arbor and chuck or an MT#3 tapered drill shank into the quill until the taper is firmly seated.

+% Turn the quill feed handwheel clockwise to feed the drill bit into the rotating workpiece.

,% To remove the chuck and arbor, turn the quill feed handle counterclockwise until the chuck is pushed out of the tailstock taper.

-20-