-29-
Df[\cD('00D]^J`eZ\/&'.
FG<I8K@FEJ
Gfn\i=\\[IXk\
=`^li\*(% Carriage lock and feed control.
Carriage Lock
Cap Screw
Half Nut
Lever
Use these steps to learn how to setup your lathe for a
power feed operation. The example in =`^li\*) shows
lathe setup for a power feed rate of 0.012". Remember,
the carriage direction is reversed when spindle rotation is
reversed.
Kfj\kXe[\e^X^\k_\gfn\i]\\[#[fk_\j\jk\gj1
(% DISCONNECT LATHE FROM POWER!
)% Turn the feed dials to the numeral and letter indi-
cated by the chart in=`^li\*).
*% Using the chart in=`^li\*), gather the required
change gears.
+% Open the side cover and use a 6mm hex wrench to
loosen the lash adjuster (=`^li\*)) and swing the
change gear assembly out of the way.
,% Remove the spindle E-clips and cap screw, lubricate,
and swap out the change gears in the order shown
on the chart in =`^li\*)%
-% Move the lash adjuster so the gear backlash is
between 0.003" to 0.008", tighten the lash adjuster
cap screw, and close the side cover.
.% Using a 5mm hex wrench, loosen the carriage lock
(=`^li\*(), and use the half nut lever to engage
and disengage the power feed when required.
=`^li\*)% Power feed setup.
+'
-'
).
,- ().
('+
Change Gears
Feed Dials
Lash Adjuster
4'%'()=\\[
Feed Chart
=\\[iXk\`jYXj\[fejg`e[c\IGD%GXp
Zcfj\ Xkk\ek`fe kf k_\ ]\\[ iXk\ pfl
_Xm\Z_fj\eXe[Y\i\X[pkf[`j\e^X^\
k_\ ZXii`X^\% =X`cli\ kf [f k_`j dXp
ZXlj\ k_\ ZXii`X^\ kf ZiXj_ `ekf k_\
Z_lZb%