Df[\cD('00D]^J`eZ\/&'.

:\ek\ij

A dead center can be used in the tailstock and lathe spindle to support workpieces. When used in this man- ner, make sure to keep the dead center tip and workpiece lubricated to prevent tip galling.

Kf`ejkXccX[\X[fic`m\Z\ek\i#[fk_\j\jk\gj1

(% Feed the quill out about 1" and insert the dead cen- ter (=`^li\)(). The mating tapers provide the lock- ing fit.

)% Move the tailstock into position and lock in place.

Efk\1DXb\jli\k_\i\`jXZ\ek\i[i`cc\[_fc\`ek_\ \e[f]k_\nfibg`\Z\]fik_\[\X[Z\ek\i%

*% Feed the quill into the workpiece. 

+% Lock the quill into place once the dead center and the workpiece rotate together. The quill may need to be adjusted during operation.

,% To remove the dead center, retract the quill until the dead center pops free.

Kf`ejkXccXeDK+[\X[Z\ek\i`ek_\jg`e[c\#[fk_\j\ jk\gj1

(% DISCONNECT POWER TO THE LATHE!

)% Remove the chuck from the spindle.

*% Install the MT#4 dead center in the spindle.

+% Attach the faceplate to the spindle, see =`^li\ )). Refer to Dflek`e^:_lZbXe[=XZ\gcXk\ on GX^\(- for details if required.

Efk\1 N_\elj`e^k_\[\X[Z\ek\i`ek_\jg`e[c\# lj\XcXk_\[f^jfk_XkpfligXikn`ccifkXk\n`k_ k_\]XZ\gcXk\Xe[efkjg`efek_\[\X[Z\ek\ik`g%

=X`cli\kfb\\g[\X[Z\ek\igf`ekn\cc clYi`ZXk\[n`cc^Xcck_\[\X[Z\ek\iXe[ nfibg`\Z\%

=`^li\)(% Inserted dead center.

=`^li\))% Faceplate and dead center

setup.

FG<I8K@FEJ

-23-

Page 25
Image 25
Woodstock M1099 manual ek\ij, Kf`ejkXccX\Xfic`m\Z\ek\i#fk\j\jk\gj1