Woodstock W1672 instruction manual Mounting Motor, Quick-Connect Cord

Figure 14. Installing pulley on motor.

Figure 15. Installing motor.

Figure 16. Plugging motor to switch.

Mounting Motor

1.Make sure the key is in place in the keyway on the motor shaft. Align the keyway and slide the motor pulley onto the motor shaft as far as it will go. Figure 14.

2.Align pulley with the hole in the back of the bandsaw body. Slide the motor until mounting holes align with those in top of the stand.

Figure 15.

3.Secure the motor with the (4) 5⁄16"-18 x 1" car- riage bolts, 5⁄16" hex nuts, lock washers and flat washers provided.

4.Line the motor pulley up with the lower wheel pulley and tighten the setscrew with the Allen® wrench provided.

Quick-Connect Cord

To eliminate troublesome wiring, the motor for your bandsaw has a quick-connect cord that leads from the motor to the switch. The recep- tacle end of this cord comes out of the bandsaw body near the motor and the plug end of the cord is already attached to the motor.

1.Locate the two plug ends and connect them together as shown in Figure 16.

2.Do Not become confused with the switch- to-power cord. It will not fit in the quick- connect receptacle. Do Not plug the switch- to-power cord into the power source at this time.

Do not rely on quick con- nect cord when making adjustments to bandsaw. Always unplug directly at the power source.

13