This equipment must be grounded. Verify that any existing electrical outlet and circuit you intend to plug into is actually grounded. If it is not, it will be necessary to run a sep- arate 12 A.W.G. copper grounding wire from the outlet to a known ground. Under no cir- cumstances should the grounding pin from any
Figure 2. Typical 220V 3-prong plug and outlet.
220V Operation
The Shop Fox® W1672 14" Bandsaw can also be operated at 220 volts. To do this, consult with the wiring diagram in the back of this manual. Also, you will need a
The motor supplied with your new bandsaw is rated at 1 H.P. and will draw approximately 6 amps during 220 volt operation. When choosing an outlet for this machine, consider using one with a 15 amp circuit breaker or fuse. Keep in mind that a circuit being used by other machines or tools at the same time will add to the total load being applied to the circuit. Add up the load ratings of all machines on the circuit. If this number exceeds the rating of the circuit break- er or fuse, use a different circuit.
Extension Cords
We do not recommend using an extension cord for 220V equipment. Instead, arrange the place- ment of your machinery and installed wiring to eliminate the need for extension cords. If you must use an extension cord, make sure it is rated Hard Service (grade S) or better. The extension cord must always contain a ground wire and plug pin. Always repair or replace extension cords when they become worn or damaged.
NOTICE
Never replace the circuit breaker with one rated at a higher amperage, or damage to the circuit may occur.
Grounding
This machine must be grounded! See Figure 2. The electrical cord supplied with the W1672 does not come with a 220 volt plug. Use a plug with a ground pin. If your outlet does not accommodate a ground pin, have it replaced by a qualified electrician or have an appropriate adapter installed and grounded properly. An adapter with a grounding wire does not guaran- tee machine will be grounded. Ground source must be verified.
7
