Figure 11. One rubber foot installed.
Main |
Table |
Hex |
Bolt |
Trunnions |
Table Support |
Lock |
Lever |
Figure 12. Main table and trunnions mounted
on the table support bracket.
Platen Stop
Platen Lock Lever
Figure 13. Tilt the platen so it is at 0˚degrees vertical and the platen has bottomed against the stop.
Feet
The rubber feet are designed to minimize vibra- tion and reduce
Wear safety glasses during assembly. Serious injury may occur if this warning is ignored!
Get moving assistance before starting assembly. The Model W1688 Edge Sander is a heavy load at 260 pounds.
To install the feet, do these steps:
1.Carefully lay the machine on its side.
2.Install the 4 feet using the supplied
1⁄2" bolts and the 1⁄4" nuts. See Figure 11.
3.Carefully upright the machine and use the bolts and nuts to adjust the feet height so the machine is stable.
Main Table
The main table is used to support the wood dur- ing vertical sanding operations and mounts the miter body.
To install the main table, do these steps:
1.Position the main table on the trunnions and install two
Figure 12.
2.Tilt the platen so it is at 0˚degrees vertical and the platen has bottomed against the stop. See Figure 13.
3.Tighten the platen lock lever. See Figure 13.
ASSEMBLY
