W1688 Edge Sander Wiring Diagram | Woodstock specs

W1688 Edge Sander Wiring Diagram

Seek assistance from a qualified electrician if you do not understand the wiring diagram in this manual, and always follow the applicable electrical codes and standards. Otherwise serious personal injury or death may occur!

Keep your machine unplugged during all elec- trical service and wiring procedures. Otherwise serious personal injury may occur!

220 VOLT CONNECTION

Red

MOTOR

TERMINAL COVER

(BACK SIDE)

Black	Yellow	Grey

Green TO GROUND

TO 220 VOLT

POWER SUPPLY

NOTE: The power-supply wires besides the green wire are interchangeable. Therefore colors are not specified on diagram.

110 VOLT CONNECTION

lack d
B	e
	R

GrYellow

ey

MOTOR

TERMINAL COVER

(BACK SIDE)

Green TO GROUND

TO 110 VOLT

POWER SUPPLY

NOTE: The power-supply wires besides the green wire are interchangeable. Therefore colors are not specified on diagram.

-36-

Image 38

Woodstock instruction manual W1688 Edge Sander Wiring Diagram

Contents

Edge Sander Page Table of Contents About Your New Edge Sander Woodstock Service and SupportIntroduction Warranty and Returns Specifications Disconnect machine when cleaning, adjusting or servicing SafetyStandard Safety Instructions Keep machine away from open flame Habits-good and bad-are hard to break Additional Safety Instructions for Edge Sanders Keep fingertips away from the moving sanding belt Avoiding Potential Injuries Do not hold wood away from the back Extension Cords 220V OperationGrounding 110V Operation Typical Nema 5-20 plug and receptacle This Page Intentionally Left Blank Unpacking AssemblyBox Contents Shop Preparation Cleaning Beginning Main Table To install the main table, do these stepsFeet Main table-tilt lock levers and scale Miter Gauge To install the quick release lever, do these stepsQuick Release Lever Sanding Belt To install the sanding belt, do these stepsDust Hood Sanding-belt quick release lever Normal operating position Auxiliary Table To install the auxiliary table, do these stepsBack Stop Adjustments Vertical Belt Tracking Diagonal Belt Tracking Diagonal belt tracking Platen-to-Roller Alignment Platen and retaining bolts Belt Tension Hex nut and belt tension rod To adjust the table height, do these steps Main Table Height Main Table Tilt Do not loosen both table tilt lock Levers at the same time Operations Starting the Sander Platen Tilting Incorrectly holding and tilting Platen Vertical Sanding Set the workpiece on the table Operation Horizontal Sanding Incorrect face sanding away from Back stop Contour Sanding Set the workpiece on the auxiliary table Troubleshooting Troubleshooting Operation This Page Intentionally Left Blank General MaintenanceLubrication Cleaning Table and Base W1688 Edge Sander Wiring Diagram Closure 6450 101 14 65 Description Tilt Plate Your Notes Your Notes BOX BELLINGHAM, WA Warranty Card