ADJUSTMENTS

Diagonal Belt

Tracking

The diagonal belt tracking for your Model W1688 Edge Sander has been setup at the factory; how- ever, due to shipping or long use of the sander, the belt can begin to track diagonally. You can compensate for this normal condition by adjust- ing the roller support bracket. See Figure 30.

Keep your machine unplugged during all assembly, adjustments, or maintenance proce- dures. Otherwise serious personal injury may occur!

To adjust the diagonal belt tracking, do these steps:

1.Unplug the edge sander.

2.Loosen the belt tracking lock knob. See

Figure 31.

3.With the sander unplugged, loosen the two

38"-16 X 112" cap screws. See Figure 32.

4.While you rotate the sanding belt in the counterclockwise operating direction, alter- nately adjust the four Allen® set screws to tilt the idler roller and roller support bracket inward or outward in very small increments. See Figure 32. By tilting the idler roller this way, the belt will track horizontally.

5.When the belt tracking is not diagonal and is horizontal, tighten the the two cap screws. See Figure 32.

6.Tighten the belt tracking lock knob.

7.Rotate the belt a few more times to make sure the belt stays in the normal operating position. If it does not, repeat steps 1 through 7.

-20-

Figure 30. Diagonal belt tracking.

Belt Tracking Lock Knob

Belt Rotation

Figure 31. Belt tracking lock knob and belt

tracking knob.

Cap Screw

Idler Roller

Support

Bracket

Allen® Set Screw

Figure 32. Roller block bracket and Allen® set

screws.

Page 22
Image 22
Woodstock W1688 instruction manual Diagonal Belt Tracking, Diagonal belt tracking