DO NOT sand a workpiece with the sharp cor- ners at the leading-edge of the sanding opera- tion. The belt can grab and propel the work- piece causing injury. See Figure 48.

5.Set the miter gauge to the needed angle.

6.Set the workpiece on the table and against the miter gauge. See Figure 49.

7.Carefully sand the wood with sharp corners at the trailing-edge of the sanding operation. See Figure 49.

OPERATION

Figure 48. DO NOT sand wood with sharp cor- ners at the leading-edge of the sanding opera- tion. The belt can grab and throw the wood.

Figure 49. ALWAYS sand wood with sharp corners at the trailing-edge of the sanding operation.

-28-

Page 30
Image 30
Woodstock W1688 instruction manual Operation