Xantrex Technology M370078-01 II Setting Up Your System, To set up your system:

Advanced Section

Figure 2-34HyperTerminal Window

Figure 2-34shows the HyperTerminal session for the combined configuration which is an ENET and RS-485 network. This figure also shows access to power supplies #2 and #10 sequentially.

Setting Up Your System

To set up your system:

1.Connect your system as shown in Figure 2-33,and turn every power supply unit to ON.

2.Set up your computer as described in “Setting Up the Computer” on page 2–6.Repeat this section for each computer hooked up to the system.

3.Install the DeviceInstaller software on the PC you wish to use to configure the XG unit (s) with. See the instructions for “Software Installations” on page 2–9.

4.Configure the ENET card of the master XG (power supply #1 in Figure 2-33). See the instructions for “Configuring the Device Using DeviceInstaller” on page 2–11.

M370078-06 2-31