Xantrex Technology TM-XDSL-01XN, XDC 6000, XDC 80-75SL manual AC Input Connector, AC Input Wire

TM-XDSL-01XN.book Page 16 Tuesday, November 5, 2002 3:22 PM

AC Input Power

AC Input Connector

AC Input Connector

The AC input connector is a standard wire clamp terminal block with 3-phase connectors and a chassis ground connector. The safety ground wire, alternatively, may be connected to the chassis using a ring tongue on the ground stud as shown in Figure 2.1.

Ground Connection

3-Phase Terminal Block Connectors

Figure 2.1 AC Input Connector

AC Input Wire

The manufacturer recommends the AC input wire specified in Table 2.1. This must be permanently connected to an approved AC distribution box with suitably rated over-current protection. If you require a special cord, contact the manufacturer.

Table 2.1 AC Wire Specification for 6000 Watt units

AC Input Voltage Range	Wire
190–242Vac, 47–63Hz,	4 x 10 AWG (3 wire plus safety ground), stranded
3-phase, 4 wire (standard)	copper, 60°C minimum, 300V, 0.800 in. maximum
	cable diameter, rated for 25A.
342–500Vac, 47–63Hz,	4 x 14 AWG (3 wire plus safety ground), stranded
3-phase, 4 wire (HV-Input)	copper, 60°C minimum, 600V, 0.800 in. maximum
	cable diameter, rated for 13A.

16 Operating Manual for XDC Series Slave Power Supply