Xantrex Technology XS400 manual Resetting After a Fault or Shutdown

Resetting After a Fault or Shutdown

Resetting After a Fault or Shutdown

This section provides explanations and procedures for resetting the XS400 after a fault or shutdown.

If you are unable to resolve the problem after referring to Table 3-3, refer to the “Troubleshooting” section on page 4–2.

Table 3-3Resetting After A Fault or Shutdown

Fault	Status	Action
Shutdown	The XS400 needs to be reset.	Turn the On/Standby switch on either the
		inverter’s front panel or the S400 Remote
		Switch to Standby (			) and then to On (	).
Short circuit	If there is a short circuit, the	Remove the short circuit then press the
	Supplemental Circuit Protection	Supplemental Circuit Protection button.
	button trips.
Ground Fault	When a fault condition is	Reset: To resume normal operation,
	detected, the Reset button on the	determine and correct the ground fault,
	GFCI outlet trips and power to the	then press the Reset button.
	appliances is interrupted.	Test: Press the Test button on the GFCI
		outlet with either shore power and/or the
		XS400 turned to On (			). The Reset button
		should trip. Press the Reset button to reset
		the GFCI and to continue with normal
		operation. This test should be performed
		on a monthly basis.
		If the Reset button does not trip, the GFCI
		may have failed. Contact your dealer to
		have a qualified service person examine
		the XS400.
Overload	The XS400 is designed to provide	Disconnect the appliances connected to
	400 watts continuously and 800	the inverter and then turn the On/Standby
	watts surge capability for five	switch on either the inverter’s front panel
	seconds. If the connected	or the S400 Remote Switch to Standby
	appliances draw more than the	(	) and then to On (	).
	rated power, the XS400 will shut
	down and the red Fault light	See also “Recharging Your Batteries
	illuminates.	When Low Battery Light Illuminates” on
		page 3–6.

975-0054-01-01 3–9