Xerox 5400 92 Xerox Phaser 5400 Laser Printer, Control Panel Messages

92 Xerox Phaser 5400 Laser Printer
Control Panel Messages
Print Using
<size> <type>
The available paper size or type does not match what was requested and the
Value key (labeled 3 or 7) was pressed.
Use the Value keys to search the trays. When you find an availab le size and
type of paper that is acceptable, press the Enter key (labeled 4). Back out of
the menu to exit. If the paper size and type that was substituted is not
acceptable, load the requested paper size and type, and print the job again.
Processing...
<Job Name>
A job is being processed with the specified name.
Processing...
Config Sheet
A Configuration Sheet is being printed.
Processing...
DEMO
A Demo Page is being printed.
Processing...
Disk Directory
The Hard Drive Directory Report is being created and printed.
Processing...
Flash Directory
The printer is printing a flash DIMM directory.
Processing…
Fault History
The printer is generating and printing a fault history log.
Processing...
Menu Map
A list of the control panel menu structure is being printed.
Processing...
PCL Font List
A PCL Font List is being printed.
Processing...
PostScript
A PostScript Font List is being printed.
Processing...
TEST
A Test Page is being printed.
Processing...
Tray n
The specified tray is being used.
Ready The printer is online and waiting for data to print.
Remove Output
From Stacker Bin
The Stacker Bin is full.
Remove the output from the Stacker Bin.
Remove Output
From Std. Bin
The Standard Bin is full.
Remove the output from the Standard Bin.
Remove Print Cart
Clear Paper Path
Appears following an initial paper jam message.
The Print Cartridge should be removed, if necessary, and the jammed paper
removed.
Close all covers and trays, then refer back to the control panel for further
messages.
Replace Print
Cartridge
The Laser Print Cartridge has reached its end of life. Printing cannot resume.
Replace the cartridge.
Stacker Bin Fail
Power Off/On
The Stacker Bin is not set normally or has failed. Printing using this bin
cannot resume.
Power OFF the printer.
Reinstall the Stacker Output Bin.
Power ON the printer.
If the problem persists, contact your Customer Support Center.
Error Description and corrective action