12 Xerox Phaser 5400 Laser Printer
Control Panel Menus
Tray Sequence Defines the order in which trays are used when more than one tray meets the
size and type requirements.
The first tray of a sequence is used (if it has the correct paper size/type) until
it runs out of paper, at which time the next tray in the sequence is used (if it
has the correct paper size/type). Refer to page 41 for more information on
automatic tray switching.
Values:
Off (no tray switching)
MBF-1 (default when no optional trays installed)
MBF-2
MBF-3
MBF-1-2
MBF-1-2-3
MBF-2-1 (default with only Tray 2 installed)
MBF-2-3
MBF-3-1
MBF-3-1-2 (default with Trays 2 and 3 installed)
MBF-3-2
1-MBF
1-2
1-2-3
2-1
2-3
3-1
3-1-2
3-2
Note: Only the trays that are installed in the printer appear in the tray
sequence.
If the value is set to Off, the printer will print only from the tray requested
by the user in the print driver, even if the other trays contain the correct
stock for that job.
Configure Custom Allows access to the setting of custom paper sizes. If this parameter is OFF,
the following entries are not visible: Custom Units, Custom X, and Custom Y.
Values:
Off (default)
On
Custom Units Specifies the units used to set custom paper size dimensions.
Values:
Inches
Millimeters
Note: When set to Inches, the default Paper Size value is Letter; the
default MBF Size is set to Letter; the default Custom Size is set to
Letter; and the default Envelope Size is set to Com10.
When set to Millimeters, the default Paper Size value is set to A4; the
default MBF Size is set to A4; the default Custom Size is set to A4; and the
default Envelope Size is set to DL.
Custom X Specifies the X dimension of the paper loaded in any trays in Custom Mode.
X direction is left-to-right in the tray.
Values:
76 mm (3.0 in.) minimum
305 mm (12 in.) maximum
216 mm (8.5 in.) (default)
Note: This parameter is not visible in the menu unless Configure
Custom is set to On.
Tray Menu Items (cont'd.)