18 Xerox Phaser 5400 Laser Printer
Control Panel Menus
Output Timeout Specifies whether the printer waits after a bin is filled or directs output to an
alternate bin.
Values:
Off (printer waits after a bin is filled)
On (default - printer directs output to an alternate bin)
Output Dest Sets the default paper output destination for PCL and PostScript jobs.
Values:
Standard Bin (default)
Stacker Bin (only shown if optional stacker bin is installed)
Print PS Errors Specifies whether to print an error page whenever a PostScript error occurs
(even if the PostScript job has an error handler that may create a separate
page).
Values:
Off (default)
On
Power Saver Specifies the number of minutes of inactivity before the printer enters a
low-power state.
Values: (in minutes)
Off (never enter Power Saver mode)
15
30
60 (default)
90
120
180
Defaults Specifies the type of factory defaults to use when a printer reset is
performed.
Values:
Inches
Millimeters
Notes: For these changes to take place, you must either power the machine
Off and then power it back On, or restart the printer from the Print or
Job Menus.
When set to Inches, the default Paper Size value is Letter; the default
MBF Size is set to Letter; the default Custom X to 8.5 inches and
Custom Y to 11 inches.
When set to Millimeters, the default Paper Size value is set to A4; the
default MBF Size is set to A4; the default Custom X to 216 mm and
Custom Y to 279 mm.
The default Form Length value in the PCL Menu is adjusted to match the
Paper Size.
Low Toner Specifies whether to continue printing when the toner in the Laser Print
Cartridge is low.
Values:
Continue (default)
Stop
Draft Adjust Controls the amount of toner saved for draft printing.
Values:
Light (67 percent) (default)
Dark (25 percent)
System Menu Items (cont'd.)